Kia Cadenza YG: Body Electrical System / Seat Electrical
- Components and Components Location
- Power Seat Motor Repair procedures
- Power Seat Control Switch Schematic Diagrams
- Power Seat Control Switch Repair procedures
- Seat Heater Components and Components Location
- Seat Heater Schematic Diagrams
- Seat Heater Repair procedures
- Seat Heater Switch Schematic Diagrams
- Seat Heater Switch Repair procedures
- Air Ventilation Seat Components and Components Location
- Air Ventilation Seat Schematic Diagrams
- Air Ventilation Seat Description and Operation
- Air Ventilation Seat Repair procedures
Inspection 1. Remove the IMS control switch connector (A). 2. With the IMS control switch in each position, make sure that continuity exists between the terminals below.
Component Location 1. Slide motor2. Front height motor3. Rear height motor4. Lumber support motor5. Power seat control switch6. Recline motor7. Recline control switch8.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Auto Head lamp leveling Unit Repair procedures
Removal Height Sensor 1. Remove the height sensor connector (A). 2. Loosen the mounting bolts(Body: 2EA, chassis: 1EA) from height sensor bracket. Tightening torque : 3 ~ 5N.m (30 ~ 50kgf.m, 2.21 ~ 3.68lb-ft) 3. Remove the height sensor.
Kia Cadenza YG 2016-2021 Service Manual: Heater Unit Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/ recycling/ charging station. 3. When the engine is cool, drain the engine coolant from the radiator. 4. Remove the expansion valve cover (A).
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Engine Mechanical System
- Battery Troubleshooting
- Engine Control / Fuel System
- New on site
- Most important about car
