Kia Cadenza YG: Seat Electrical / Air Ventilation Seat Description and Operation

Kia Cadenza YG 2016-2021 Service Manual / Body Electrical System / Seat Electrical / Air Ventilation Seat Description and Operation

Description
Using the blows power of FAN on seat, remove the moisture, sweat and warmth from occupants and surface of seats.
It inhales the indoor air through the blower installed at the seat cushion lower part, and supplies the air into the seat cushion and the seat back through the duct.
It sends a slight air throughout the seat surface through the air channel set up at seat cushion and seat back.
   
1)
Make sure not to spoil drink or water on the seat when equipping with ventilation system seat
2)
Because of inhaling the slight air, it is difficult to feel the air strength by the sense of touch.

    Circuit Diagram

    Removal [Front Seat] 1. Remove the front seat assembly. (Refer to Body - "Front Seat") 2. Remove the seat back cover and cushion cover. (Refer to Body - "Front Seat") 3.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Adaptive Front Lighting System Description and Operation

    Description AFLS Unit(ECU) AFLS located in Cockpit Module is provided information of vehicle (steering wheel signal,vehicle speed, inclination of vehicle). Based on provided information , it calculates algorithm and adjust Low beam of H/Lamp. It transmits driving information by using LIN protocol, it is operated in Fail-safe reaction mode

    Kia Cadenza YG 2016-2021 Service Manual: Pantoscopic Camera Repair procedures

    Removal Front Pantoscopic Camera 1. Disconnect the negative (-) battery terminal. 2. Remove the front bumper cover. (Refer to Body - "Front Bumper Cover") 3. Remove the pantocscpic camera (B) after loosening the mounting screws and connector (A).

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0303