Kia Cadenza YG: Seat Electrical / Power Seat Control Switch Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Body Electrical System / Seat Electrical / Power Seat Control Switch Repair procedures

Inspection
With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch.
A : Power seat control switch
B : Lumber support switch

   
In case of IMS switch inspection, refer to "IMS" system.

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the switchs (A) from seat side cover.

3.
Remove the seat side cover (A).
(Refer to Body - "Front Seat")

4.
Disconnect the power seat control switch connector (A).

5.
Loosen the power seat control switch (A) mounting screws (3EA).

Installation
   
–
Make sure that the IMS control switch connectors and related connectors are plugged in properly.
–
Check the IMS control switch operates normally.
1.
Connect the connectors and reassemble the IMS control switch.
2.
Reassemble the seat side cover.

    Circuit Diagram

    Component Location

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Adaptive Front Lighting System Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the crash pad side cover (A). [RH] 3. Disconnect the stopper (B) from the glove box (A). 4. Disconnect the air damper (A) from the glove box (B).

    Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Radar Calibration Description and Operation

    Description To sense the cars exactly in the next lane with the radar, the direction of the sensor and the direction of the vehicle have to align. This is BSD unit alignment. If this alignment is not performed as below illustration, the degradation of detection performance and the cause of false alarms.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0314