Kia Cadenza YG: Emission Control System / Specifications

Kia Cadenza YG 2016-2021 Service Manual / Emission Control System / Specifications

Specifications
Purge Control Solenoid Valve (PCSV)
▷ Specification
Item
Specification
Coil Resistance (Ω)
22.0 ~ 26.0 [20°C(68°F)]

Fuel Tank Pressure Sensor (FTPS)
▷ Type: Piezo-Resistive Pressure Sensor
▷ Specification
Pressure (kPa)
Output Voltage (V)
-6.67
0.5
0
2.5
+6.67
4.5

Canister Close Valve (CCV)
▷ Specification
Item
Specification
Coil Resistance (Ω)
19.8 ~ 21.8 [20°C(68°F)]

Tightening Torques
Item
kgf.m
N.m
lb-ft
Positive Crankcase Ventilation (PCV) Valve installation
0.8 ~ 1.2
7.8 ~ 11.8
5.8 ~ 8.7
Canister installation bolt
0.4 ~ 0.6
3.9 ~ 5.9
2.9 ~ 4.3
Canister protector installation bolt
0.9 ~ 1.4
8.8 ~ 13.7
6.5 ~ 10.1
ORVR installation bolt
0.2 ~ 0.3
1.9 ~ 2.9
1.4 ~ 2.1

    Components Location 1. PCV Valve2. Canister3. Purge Control Solenoid Valve (PCSV)4. Fuel Tank Pressure Sensor (FTPS)5. Canister Close Valve (CCV)6.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower unit.(Refer to HA group – heater unit). 3. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws.     Make sure that there is no air leaking out of the blower and duct joints.

    Kia Cadenza YG 2016-2021 Service Manual: Power Mosfet Repair procedures

    Inspection 1. Ignition "ON" 2. Manually operate the control switch and measure the voltage of blower motor. 3. Select the control switch to raise voltage until high speed. Specification FanMotor VoltageManualFirst speed3.8 ±0.5VSecond speed5.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.028