Kia Cadenza YG: Emission Control System
Kia Cadenza YG 2016-2021 Service Manual / Emission Control System
- Specifications
- Components and Components Location
- Description and Operation
- Schematic Diagrams
- Troubleshooting
- Crankcase Emission Control System
- Schematic Diagrams
- Repair procedures
- Positive Crankcase Ventilation (PCV) Valve Description and Operation
- Positive Crankcase Ventilation (PCV) Valve Repair procedures
- Evaporative Emission Control System
- Description and Operation
- Schematic Diagrams
- Canister Repair procedures
- On-board Refueling Vapor Recovery (ORVR) valve Description and Operation
- On-board Refueling Vapor Recovery (ORVR) valve Repair procedures
- Fuel Filler Cap Description and Operation
- Fuel Tank Air Filter Repair procedures
- Exhaust Emission Control System
Inspection [Measuring Resistance] 1. Disconnect the cruise control switch connector from the control switch. 2. Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).
Specifications Purge Control Solenoid Valve (PCSV) ▷ Specification ItemSpecificationCoil Resistance (Ω)22.0 ~ 26.0 [20°C(68°F)] Fuel Tank Pressure Sensor (FTPS) ▷ Type: Piezo-Resistive Pressure Sensor ▷ Specification Pressure (kPa)Output Voltage (V)-6.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Components and Components Location
C
Kia Cadenza YG 2016-2021 Service Manual: Start/Stop Button Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screw driver or remover, remove the center fascia lower panel (A). 3. Remove the in-car hose (A) and disconnect the connectors (B) from the heater & A/C control unit. 4.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Timing Chain Repair procedures
- Steering System
- Engine Electrical System
- New on site
- Most important about car
Copyright © 2026 www.kcadenzavg.com - 0.0291