Kia Cadenza YG: Evaporative Emission Control System / On-board Refueling Vapor Recovery (ORVR) valve Description and Operation
| Operation |
| Normal status | Full fuel | Vehicle Rollover / steep |
| Valve open | Valve close | Valve close |
|
|
|
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the ventilation hose (A) from the fuel tank air filter.
Removal 1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Remove the fuel tank. (Refer to Fuel System - "Fuel Tank") 3.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Immobilizer Control Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening the bolt. Installation 1.
Kia Cadenza YG 2016-2021 Service Manual: Auto defoging sensor Repair procedures
Inspection 1. Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch. DisplayFail description00Normal23Auto defog sensor OPEN24Auto defog sensor SHORT43Defog door potentiometer OPEN/SHORT44Defog door potentiometer * Diagnostic procedure refer to DTC code.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Restraint
- Crankshaft Damper Pulley Components and Components Location
- Engine Control / Fuel System
- New on site
- Most important about car
