Kia Cadenza: Lighting / Turn signals and lane change signals

Kia Cadenza YG 2016-2025 Owners Manual / Features of your vehicle / Lighting / Turn signals and lane change signals

The Engine Start/Stop button must be on for the turn signals to function. To turn on the turn signals, move the lever up or down (A). The green arrow indicators on the instrument panel indicate which turn signal is operating.

They will self-cancel after a turn is completed. If the indicator continues to flash after a turn, manually return the lever to the OFF position.

To signal a lane change, move the turn signal lever slightly and hold it in position (B). The lever will return to the OFF position when released.

If an indicator stays on and does not flash or if it flashes abnormally, one of the turn signal bulbs may be burned out and will require replacement.

One-touch Turn signal lamp

When you change lanes, even if the turn signal lamp lever returns to its original position after move the turn signal lever slightly to B position, the turn signal lamp will blink 3 times (or 5, 7 times).

This is a feature that helps you continue to operate even if you are not holding the turn signal lever when changing lanes. You may change the number of blink (3, 5 or 7 times) or deactivate the one touch turn signal lamp function from the Infotainment System as ‘Settings → Vehicle → Lights → One Touch Turn Signal’.

✽ NOTICE

If an indicator flash is abnormally quick or slow, a bulb may be burned out or have a poor electrical connection in the circuit.

System setting
By selecting as ‘Settings →Vehicle → Lights → High Beam Assist’ on the instrument cluster infotainment system at engine on, you may select or release the system. The settings will ...

Check headlight
This warning message illuminates if there is a malfunction (burned-out bulb except LED lamp or circuit malfunction) with the headlamp. In this case, have your vehicle inspected by an autho ...

Other information:

Kia Cadenza YG 2016-2025 Service Manual: Manifold Absolute Pressure Sensor (MAPS) Repair procedures


Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. ConditionOutput Voltage (V)IG ONApprox. 4.44VIdleApprox. 0.75V Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2 ...

Kia Cadenza YG 2016-2025 Service Manual: Audio Unit Components and Components Location


Components Connector Pin Information Pin No.Connector AConnector BConnector C1Rear left speaker (+)CAN highPower ground2Front left speaker (+)--3Front right speaker (+)--4Rear right speaker (+)Steering wheel remote-5---6-USB D (+)-7-USB/iPod VDDMonitor Rx DP8Illumination (+)AUX right inputMoni ...

Copyright © www.kcadenzavg.com 2017-2025