Other information:
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
ConditionOutput Voltage (V)IG ONApprox. 4.44VIdleApprox. 0.75V
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2 ...
Rear Combination Lamp (Outside)
1.
Disconnect the negative (-) battery terminal.
2.
If the bulbs should be only replaced without removing lamp
assembly, replace the turn signal lamp bulb (B) after removing the trim
cover (A) in the trunk.
3.
Remove the nuts (4EA).
4.
Remove the r ...