Kia Cadenza YG: Evaporative Emission Control System / Fuel Filler Cap Description and Operation

Kia Cadenza YG 2016-2021 Service Manual / Emission Control System / Evaporative Emission Control System / Fuel Filler Cap Description and Operation

Description
A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which would seal the fuel filler. After the gasket on the fuel filler cap and the filler neck flange contact each other, the ratchet produces a loud clicking noise indicating the seal has been set.

1. Cover
2. Torsion spring
3. Retainer
4. Gasket seal
5. Spring
6. Plate seal
7. Vacuum valve
8. Spring

    Removal 1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Remove the fuel tank. (Refer to Fuel System - "Fuel Tank") 3.

    Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Lift the vehicle. 3. Disconnect the canister close valve connector (A).

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Antenna Coil Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening the screw.

    Kia Cadenza YG 2016-2021 Service Manual: Condenser Repair procedures

    Inspection 1. Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air. If bent, gently bend them using a screwdriver or pliers. 2. Check the condenser connections for leakage, and repair or replace it, if required.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0221