Kia Cadenza YG: Evaporative Emission Control System / On-board Refueling Vapor Recovery (ORVR) valve Repair procedures
| Removal |
| 1. |
Turn the ignition switch OFF, and then remove battery (-) cable. |
| 2. |
Remove the fuel tank.
(Refer to Fuel System - "Fuel Tank") |
| 3. |
Disconnect the vapor hose (A). |
| 4. |
Remove installation bolts (B), and then remove the ORVR valve (C) from the fuel tank,
|
| Inspection |
| 1. |
Visually check if the valve and gasket seal are deformed or damaged. |
| 2. |
Check if the air is passed smoothly when blowing into the nipple of ORVR valve as below position.
|
| 3. |
Check if there is resistance when blowing into the nipple of ORVR valve as below position.
|
| Installation |
| 1. |
Install in the reverse order of removal.
|
Operation Normal status Full fuelVehicle Rollover / steepValve openValve closeValve close
Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which would seal the fuel filler.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Specifications
Specification ItemSpecificationUltrasonic sensorVoltage ratingDC 12 VDetecting range30 cm ~ 120 cmOperation voltageDC 9 ~ 16 VOperation currentMAX 300 mAOperation temperature-30°C ~ +80°C (-22°C ~ +176°C)Operation frequency48 ± 5 KHzEffective operating velocity10 KPH (6.
Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting screws. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Suspension System
- Automatic Transaxle System
- Engine Control / Fuel System
- New on site
- Most important about car
