Kia Cadenza YG: Crankcase Emission Control System / Positive Crankcase Ventilation (PCV) Valve Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Emission Control System / Crankcase Emission Control System / Positive Crankcase Ventilation (PCV) Valve Repair procedures

Removal
1.
Disconnect the vapor hose (A).
2.
Remove the PCV valve (B).

Inspection
1.
Insert a thin stick (A) into the PCV valve (B) from the threaded side to check that the plunger moves.

   
If the plunger does not move (PCV valve is clogged), clean or replace the valve.
Installation
1.
Install in the reverse order of removal.
PCV Valve installation :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

    Operation Principle

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Components and Components Location

    Component Location Components 1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Blower Upper Case10. Blower Lower Case11. FET12. Resistor13.

    Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower unit.(Refer to HA group – heater unit). 3. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws.     Make sure that there is no air leaking out of the blower and duct joints.

    Categories

     
    Copyright © 2025 www.kcadenzavg.com - 0.0218