| Component Location |

| 1. Start Stop Button(SSB) 2. FOB key 3. RF receiver 4. Smart key unit 5. Interior antenna 1 6. Interior antenna 2 | 7. Trunk antenna 8. Bumper antenna 9. Door handle & door antenna 10. Trunk lid open switch 11. IPM (Intelligent intergrated Platform Module) |
Circuit Diagram (1) Circuit Diagram (2)
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting screws. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Inspection 1. Ignition "OFF” 2. Disconnect the connector of mode control actuator. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the terminal 3and grounding terminal 7. 4. Verify that the mode control actuator operates to the vent mode when connecting in the reverse.