Kia Cadenza: Low tire pressure telltale / TPMS (Tire Pressure Monitoring System) malfunction indicator

Kia Cadenza YG 2016-2025 Owners Manual / What to do in an emergency / Tire Pressure Monitoring System (TPMS) / Low tire pressure telltale / TPMS (Tire Pressure Monitoring System) malfunction indicator

The low tire pressure telltale will illuminate after it blinks for approximately one minute when there is a problem with the Tire Pressure Monitoring System. If the system is able to correctly detect an underinflation warning at the same time as system failure then it will illuminate both the TPMS malfunction and low tire pressure position telltales e.g. if Front Left sensor fails, the TPMS malfunction indicator illuminates, but if the Front Right, Rear Left, or Rear Right tire is under-inflated, the low tire pressure position telltales may illuminate together with the TPMS malfunction indicator.

Have the system checked by an authorized Kia dealer as soon as possible to determine the cause of the problem.

CAUTION

Low tire pressure telltale
When the tire pressure monitoring system warning indicators are illuminated, one or more of your tires is significantly under-inflated. If the telltale illuminates, immediately reduce your ...

Changing a tire with TPMS
If you have a flat tire, the Low Tire Pressure telltale will come on. Have the flat tire repaired by an authorized Kia dealer as soon as possible or replace the flat tire with the spare tire ...

Other information:

Kia Cadenza YG 2016-2025 Service Manual: IMS Control Switch Repair procedures


Inspection 1. Disconnect the IMS control switch connector. 2. With the power IMS control switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the IMS control switch. Removal 1. Disconnect the negative (-) b ...

Kia Cadenza YG 2016-2025 Service Manual: Panoramaroof Motor Repair procedures


Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim. (Refer to Body - "Roof Trim") 3. Disconnect the panoramaroof motor (A) connector. 4. Ground the terminals as below table, and check that the panoramaroof unit operates.     ...

Copyright © www.kcadenzavg.com 2017-2025