Kia Cadenza YG: Seat Electrical / Air Ventilation Seat Description and Operation

Kia Cadenza YG 2016-2021 Service Manual / Body Electrical System / Seat Electrical / Air Ventilation Seat Description and Operation

Description
Using the blows power of FAN on seat, remove the moisture, sweat and warmth from occupants and surface of seats.
It inhales the indoor air through the blower installed at the seat cushion lower part, and supplies the air into the seat cushion and the seat back through the duct.
It sends a slight air throughout the seat surface through the air channel set up at seat cushion and seat back.
   
1)
Make sure not to spoil drink or water on the seat when equipping with ventilation system seat
2)
Because of inhaling the slight air, it is difficult to feel the air strength by the sense of touch.

    Circuit Diagram

    Removal [Front Seat] 1. Remove the front seat assembly. (Refer to Body - "Front Seat") 2. Remove the seat back cover and cushion cover. (Refer to Body - "Front Seat") 3.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Schematic Diagrams

    Circuit Diagram SVM System Input/Output 1. Camera input ItemSpecificationLens angle of view190 degreesAngle of viewHorizontal186 degreesVertical135 degreesFunctionProvides the original image of the wide angle image (no additional function)Application locationSame camera applied to the front, rear, left and right 2.

    Kia Cadenza YG 2016-2021 Service Manual: Temperature Control Actuator Repair procedures

    Inspection 1. Ignition "OFF" 2. Disconnect the connector of temperature control actuator. 3. Verify that the temperature control actuator operates to the hot position when connecting 12V to the terminal 3 and grounding terminal 7. Verify that the temperature control actuator operates to the cool position when connecting in the rev

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0251