Kia Cadenza: Warning message and control / Blind-Spot Collision Warning
First stage alert
.jpg)
If a vehicle is detected within the
boundary of the system, a warning
light will illuminate on the outside
rearview mirror.
Once the detected vehicle is no
longer within the blind spot area, the
warning will turn off according to the
driving conditions of the vehicle.
Second stage alert
.jpg)
[A] :Warning sound
A warning chime to alert the driver
will activate when:
1. At the First stage alert (the warning
light illuminate on the outside
review mirror AND,
2. The turn signal is applied (same
side as where the vehicle is being
detected).
When this alert is activated, the warning
light on the outside rearview mirror
will also blink. And a warning chime
will sound.
If you turn off the turn signal indicator,
the second stage alert will be deactivated.
Once the detected vehicle is no
longer within the warning area, the
warning will turn off according to the
driving conditions of the vehicle.
WARNING
- The warning light on the outside
rearview mirror will illuminate
whenever a vehicle is
detected at the rear side by
the system.
To avoid accidents, do not
focus only on the warning
light and neglect to see the
surrounding of the vehicle.
- Drive safely even though the
vehicle is equipped with a
Blind-Spot Collision Warning.
Do not solely rely on the system
but check your surrounding
before changing lanes or
backing the vehicle up.
- The system may not alert the
driver in some conditions so
always check your surroundings
while driving.
CAUTION
- The driver should always exercise
extreme caution while
operating the vehicle, whether
or not the warning light on the
outside rearview mirror illuminates
or there is a warning
alarm.
- Playing the vehicle audio system
at high volume may prevent
you from hearing Blind-
Spot Collision Warning
sounds.
- The warning of Blind-Spot
Collision Warning may not
sound while other system's
warning sounds.
Blind-Spot Collision-Avoidance
Assist may apply braking power,
when an approaching vehicle is
detected within a certain distance
next to/behind your vehicle.
It gently applies braking pow ...
Other information:
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the floor console.
(Refer to the Body - "Console")
3.
After removing the bolt (A), remove the rear vent duct (B).
4.
Disconnect the yaw rate & lateral G sensor connector (A).
5.
Rem ...
Removal and Installation
To avoid damage, unplug the wiring connectors carefully while holding the connector portion.
Mark all wiring and hoses to avoid misconnection.
1.
Drain the coolant.
(Refer to Cooling System – “Coolantâ ...