Kia Cadenza YG: Starting System / Description and Operation

Kia Cadenza YG 2016-2021 Service Manual / Engine Electrical System / Starting System / Description and Operation

Description
The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery cable.
When the ignition key is turned to the start position, current flows and energizes the starter motor''s solenoid coil.
The solenoid plunger and clutch shift lever are activated, and the clutch pinion engages the ring gear.
The contacts close and the starter motor cranks.
In order to prevent damage caused by excessive rotation of the starter armature when the engine starts, the clutch pinion gear overruns.

1. Solenoid
2. Brush assembly
3. Armature
4. Overrun clutch

    Troubleshooting     • The battery must be in good condition and fully charged for this troubleshooting.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Adaptive Front Lighting System Description and Operation

    Description AFLS Unit(ECU) AFLS located in Cockpit Module is provided information of vehicle (steering wheel signal,vehicle speed, inclination of vehicle). Based on provided information , it calculates algorithm and adjust Low beam of H/Lamp. It transmits driving information by using LIN protocol, it is operated in Fail-safe reaction mode

    Kia Cadenza YG 2016-2021 Service Manual: Compressor Repair procedures

    Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative cable from the battery. 3. Recover the refrigerant with a recovery/charging station.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0215