Kia Cadenza YG: Timing System / Drive Belt Tensioner Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Engine Mechanical System / Timing System / Drive Belt Tensioner Repair procedures

Removal and Installation
1.
Remove the drive belt idler.
(Refer to Timing System - "Idler")
2.
Remove the drive belt auto tensioner (A).
Tightening torque
Bolt (B) :
81.4 ~ 85.3N.m (8.3 ~ 8.7kgf.m, 60.0 ~ 62.9lb-ft)
Bolt (C) :
17.7 ~ 21.6N.m (1.8 ~ 2.2kgf.m, 13.0 ~ 15.9lb-ft)

3.
Installation is reverse order of removal
Inspection
Check the belt tensioner for excessive dust, crack, and damage. Replace if necessary.

    Components 1. Drive belt tensioner

    Components 1. Crankshaft damper pulley

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Radar Calibration Description and Operation

    Description To sense the cars exactly in the next lane with the radar, the direction of the sensor and the direction of the vehicle have to align. This is BSD unit alignment. If this alignment is not performed as below illustration, the degradation of detection performance and the cause of false alarms.

    Kia Cadenza YG 2016-2021 Service Manual: Heater Unit Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/ recycling/ charging station. 3. When the engine is cool, drain the engine coolant from the radiator. 4. Remove the expansion valve cover (A).

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0255