Kia Cadenza: Features of your vehicle / Fuel filler door
Opening the fuel filler door
.jpg)
The fuel filler door must be opened from inside the vehicle by pressing the fuel filler door opener button.
If the fuel filler door does not open because ice has formed around it, tap lightly or push on the door to break the ice and release the door. Do not pry on the door. If necessary, spray around the door with an approved de-icer fluid (do not use radiator anti-freeze) or move the vehicle to a warm place and allow the ice to melt.
.jpg)
1. Stop the engine.
2. To open the fuel filler door, push the fuel filler door opener button.
3. Pull open the fuel filler door (1).
4. To remove the cap, turn the fuel filler cap (2) counterclockwise.
5. Refuel as needed.
WARNING
Before refueling, be sure to check what type of fuel is used for your vehicle.
If you put diesel fuel into a gasoline- powered vehicle or gasoline into a diesel-powered vehicle, it may affect the fuel system and cause serious damage to the vehicle.
Closing the hood
1. Before closing the hood, check the
following:
All filler caps in engine compartment
must be correctly installed.
Gloves, rags or any other combustible
material must be
removed from ...
Closing the fuel filler door
1. To install the cap, turn it clockwise
until it “clicks” once. This indicates
that the cap is securely tightened.
2. Close the fuel filler door and push
it in lightly making sure that it ...
Other information:
Kia Cadenza YG 2016-2025 Service Manual: CVVT Oil Temperature Sensor (OTS) Description and Operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine speed and load. By controlling CVVT, the valve over-lap or under-lap occurs, which m ...
Kia Cadenza YG 2016-2025 Service Manual: Smart Cruise Control Switch Repair procedures
Inspection [Measuring Resistance] 1. Disconnect the cruise control switch connector from the control switch. 2. Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed). Function switchTerminalResistance (±5%) [kΩ]CANCEL2 - ...
