Kia Cadenza YG: Fuel Filler Door / Fuel Filler Door Release Actuator Repair procedures
| Inspection |
| 1. |
Open the fuel filler door and remove the fuel filler door release actuator (A) after loosening the mounting bolts.
|
| 2. |
Remove the trunk room left side trim.
(Refer to Body - "Interior Trim") |
| 3. |
Disconnect the release actuator connector (A).
|
| 4. |
Check for continuity between terminal No.1 and No.2.
If there is no continuity, replace the fuel filler door opener. |
Component Location 1. Fuel filler door open switch2. Fuel filler door release actuator
Inspection 1. Open the junction box fuse cover. 2. Insert the hand to the junction box fuse cover hole and remove the crash pad side switch assembly (A) by pushing it.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Surround View Monitoring Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the floor console upper cover. (Refer to Body - "Floor Console Assembly") 3. Disconnect the console upper cover connector (A). 4. Remove the cup holder assembly (A) after loosening the mounting screws.
Kia Cadenza YG 2016-2021 Service Manual: Receiver-Drier Repair procedures
Replacement 1. Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser. Tightening torque : 9.8~14.7N.m (1.0~1.5kgf.m, 7.2~10.8 lb-ft) 2. Remove the desiccant (A) from condenser using a long nose plier.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Rail Pressure Sensor (RPS) Schematic Diagrams
- Engine Mechanical System
- Body Electrical System
- New on site
- Most important about car
