| Inspection |
| 1. |
Open the junction box fuse cover. |
| 2. |
Insert the hand to the junction box fuse cover hole and remove the crash pad side switch assembly (A) by pushing it.
|
| 3. |
Disconnect the switch connector. |
| 4. |
Check for continuity between the terminal No.4 and No.5.
If there is no continuity, replace the fuel filler door open switch.
|
Inspection 1. Open the fuel filler door and remove the fuel filler door release actuator (A) after loosening the mounting bolts. 2. Remove the trunk room left side trim.
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the LDWS unit cover (A). 3. Remove the LDWS unit connector (A). 4. Remove the LDWS unit after widening the mounting clips. Installation 1. Install the LDWS unit. 2.
Inspection 1. Ignition "ON" 2. Using the scan tool. 3. Emit intensive light toward photo sensor using a lamp, and check the output voltage change. 4. The voltage will rise with higher intensive light and reduce with lower intensive light.