Kia Cadenza YG: Fuel Filler Door / Fuel Filler Door Release Actuator Repair procedures
| Inspection |
| 1. |
Open the fuel filler door and remove the fuel filler door release actuator (A) after loosening the mounting bolts.
|
| 2. |
Remove the trunk room left side trim.
(Refer to Body - "Interior Trim") |
| 3. |
Disconnect the release actuator connector (A).
|
| 4. |
Check for continuity between terminal No.1 and No.2.
If there is no continuity, replace the fuel filler door opener. |
Component Location 1. Fuel filler door open switch2. Fuel filler door release actuator
Inspection 1. Open the junction box fuse cover. 2. Insert the hand to the junction box fuse cover hole and remove the crash pad side switch assembly (A) by pushing it.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting screws. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Components and Components Location
Component Location Components 1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Blower Upper Case10. Blower Lower Case11. FET12. Resistor13.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Schematic Diagrams
- Timing Chain Repair procedures
- Steering System
- New on site
- Most important about car
