Kia Cadenza YG: Blower / Intake Actuator Description and Operation
Kia Cadenza YG 2016-2021 Service Manual / Heating,Ventilation, Air Conditioning / Blower / Intake Actuator Description and Operation
| Description |
| 1. |
The intake actuator is located at the blower unit. |
| 2. |
It regulates the intake door by signal from control unit. |
| 3. |
Pressing the intake selection switch will shift between recirculation and fresh air modes. |
Component Location
Inspection 1. Ignition "OFF". 2. Disconnect the intake actuator connector. 3. Verify that the actuator operates to the recirculation position when connecting 12V to the terminal 3 and grounding terminal 7.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the passenger compartment junction box cover. 3. Remove the driver side cover (A). 4. Remove the crash pad side switch assembly (A) by pushing it through side cover hole.
Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Components and Components Location
Component Location Components 1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Blower Upper Case10. Blower Lower Case11. FET12. Resistor13.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Body Electrical System
- Engine Mechanical System
- Suspension System
- New on site
- Most important about car
Copyright © 2026 www.kcadenzavg.com - 0.0288