Kia Cadenza YG: Ignition System / Ignition Coil Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Engine Electrical System / Ignition System / Ignition Coil Repair procedures

Removal
[Ignition Coil #2, #4, #6]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the engine cover.
3.
Disconnect the ignition coil connector (A).
4.
Remove the ignition coil after loosening the bolts (B).

   
•
When removing the ignition coil connector, pull the lock pin (A) and push the clip (B).

[Ignition coil #1, #3, #5]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the engine cover.
3.
Remove the surge tank assembly.
(Refer to Engine Mechanical System - "Surge Tank")
4.
Disconnect the ignition coil connector (A).
5.
Remove the igniton coil after loosening the bolts (B).

   
•
When removing the ignition coil connector, pull the lock pin (A) and push the clip (B).

Installation
1.
Install in the reverse order of removal.
Ignition coil installation bolts:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft)
Inspection
1.
Measure the primary coil resistance between terminals (+) and (-).

Standard value: 0.62Ω ± 10%

    Circuit Diagram

    Description A spark plug is a device for delivering electric current from an ignition system to the combustion chamber of a spark-ignition engine to ignite the compressed fuel/air mixture therein by means of an electric spark, while containing combustion pressure within the engine.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Immobilizer Control Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening the bolt. Installation 1.

    Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Radar Calibration Description and Operation

    Description To sense the cars exactly in the next lane with the radar, the direction of the sensor and the direction of the vehicle have to align. This is BSD unit alignment. If this alignment is not performed as below illustration, the degradation of detection performance and the cause of false alarms.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0286