| Removal |
| 1. |
Remove the negative (-) battery terminal. |
| 2. |
Remove the driver seat in the car.
(Refer to Body - "Front Seat") |
| 3. |
Remove the IMS module (A) after loosening 3 screws in the bottom of seat.
|
| 4. |
Disconnect the IMS module connector (A) and then remove the IMS module (B).
|
| Installation |
| 1. |
Install the IMS module after reconnecting the connector. |
| 2. |
Install the driver seat.
|
Description system outline An optimal seat position set by a driver can be memorized in Power seat unit by IMS SW, which enables restoration of seat position set by the driver despite Playing of this function during drive is banned for safety reasons, and it has emergency stop function of restoration and gearing operation as well Input Specification 1.
Circuit diagram
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening the screw.
Description Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through the ECM (Reverse Display Room Mirror) mirror or AVN head unit while backing-up.