Kia Cadenza YG: BCM (Body Control Module) / Body Control Module (BCM) Components and Components Location

Kia Cadenza YG 2016-2021 Service Manual / Body Electrical System / BCM (Body Control Module) / Body Control Module (BCM) Components and Components Location

Components

Connector Pin Information
No.
Connector G
Connector H
Connector K
Connector L
1
Power ground
Front fog lamp switch
Room lamp
Front left turn signal lamp
2
Washer switch
PAS OFF switch
Rear power window relay power
LED DRL - LH
3
Security indicator
Defroster
Rear right power window up relay
LED DRL - RH
4
Assist seat belt switch
Auto light switch
Rear left power window up relay
Rain sensor option
5
Head lamp washer
Tail switch
Driver door open switch
-
6
Wiper intermittent volume
Left turn signal lamp switch
Assist door open switch
-
7
Body load
K Line
Driver seat belt switch
-
8
PAS OFF indicator
PAS/RPAS option
Rear right door unlock
-
9
C CAN low
MTS data
Rear left door unlock
External buzzer
10
C CAN high
BCM data
LIN
Front right turn signal lamp
11
Auto light ground
Key insert signal
-
Wiper low relay
12
AV tail
Rear fog lamp switch
Rear left turn signal lamp
ATM solenoid
13
Signal ground
B CAN low
Foot lamp
Hood switch
14
Kel solenoid
B CAN high
Trunk room lamp
-
15
Key hole illumination
Head lamp high switch
Rear right power window down relay
-
16
-
Wiper intermittent switch
Rear left power window down relay
HID option
17
-
Wiper mist switch
P position
Wiper high relay
18
Rear fog lamp relay
Right turn signal lamp switch
Rear right door open swith
Wiper stop status
19
Trunk release relay
Parking brake switch
Rear left door open swith
　
20
Auto light power
Side airbag option
Trunk open status
21
Frong fog lamp LED option
Passing switch
External trunk switch
22
Stop lamp switch
Head lmap low switch
Rain sensor input
23
Auto light sensor
Hazard switch
Rain sensor output
24
Burglar alarm horn relay
-
Rear right turn signal lamp
25
-
　
　
26
Assist seat belt indicator

    Specifications ItemsSpecificationsRated voltageDC 12VOperating voltageDC 9 ~ 16VOperating temperature-22°F ~ 167°F (-30°C ~ 75°C)Dark currentKeyless type : Max.

    Circuit Diagram

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Adaptive Front Lighting System Description and Operation

    Description AFLS Unit(ECU) AFLS located in Cockpit Module is provided information of vehicle (steering wheel signal,vehicle speed, inclination of vehicle). Based on provided information , it calculates algorithm and adjust Low beam of H/Lamp. It transmits driving information by using LIN protocol, it is operated in Fail-safe reaction mode

    Kia Cadenza YG 2016-2021 Service Manual: Receiver-Drier Repair procedures

    Replacement 1. Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser. Tightening torque : 9.8~14.7N.m (1.0~1.5kgf.m, 7.2~10.8 lb-ft) 2. Remove the desiccant (A) from condenser using a long nose plier.

    Categories

     
    Copyright © 2025 www.kcadenzavg.com - 0.0185