Kia Cadenza YG: Fuel Delivery System / Components and Components Location

Kia Cadenza YG 2016-2021 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Components and Components Location

Components Location
[Fuel Tank]

1. Fuel Tank
2. Fuel Pump
3. Fuel Filter
4. Fuel Pressure Regulator
5. Canister
6. Fuel Tank Air Filter
7. Fuel Pressure Sensor (FPS)
8. Fuel Tank Pressure Sensor (FTPS)
9. Canister Close Valve (CCV)
10. Fuel Level Sender (FLS)
11. Fuel Pump Control Module (FPCM)
12. Fuel Filler Hose
13. Ventilation Hose
14. Vapor Tube
15. Fuel Pump Plate Cover
16. Fuel Tank Band

[Fuel Pump Assembly]

1. Fuel Pump Plate Cover
2. Head Assembly
3. Fuel Filter
4. Fuel Pressure Regulator
5. Fuel Pump Motor
6. Pre-filter
7. Reservoir-cup
8. Fuel Sender

[High Pressure Fuel Line]

1. High Pressure Fuel Pump
2. High Pressure Fuel Pipe
3. Delivery Pipe
4. Injector

   
In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do any repair work right after engine stops.

    Fuel Pressure Test (Low pressure system) 1. Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line").

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Specifications

    S

    Kia Cadenza YG 2016-2021 Service Manual: Blower Resistor Repair procedures

    Inspection 1. Measure terminal - to - terminal resistance of blower resistor. 2. If measure resistance isnot within specification, the blower resistor must be replaced. Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower cover (A) and then disconnect the connector (B).

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0223