Kia Cadenza YG: Cylinder Block / Drive Plate Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Engine Mechanical System / Cylinder Block / Drive Plate Repair procedures

Removal and Installation
1.
Remove the automatic transaxle .
(Refer to Automatic Transaxle System - "Automatic Transaxle")
2.
Remove the adapter plate (A) and the drive plate (B).
Tightening torque :
71.6 ~ 75.5 N.m (7.3 ~ 7.7 kgf.m, 52.8 ~ 55.7 lb-ft)

3.
Install in the reverse order of removal.

    Components 1. Drive plate2. Adapter plate

    Components 1. Rear oil seal2. Oil seal case

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Start/Stop Button Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screw driver or remover, remove the center fascia lower panel (A). 3. Remove the in-car hose (A) and disconnect the connectors (B) from the heater & A/C control unit. 4.

    Kia Cadenza YG 2016-2021 Service Manual: Refrigerant line Repair procedures

    Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace faulty tube or hose.     Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten joint of bolt or nut to specified torque.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0234