Kia Cadenza YG: Automatic Transaxle Control System / Input Speed Sensor Specifications

Kia Cadenza YG 2016-2021 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Input Speed Sensor Specifications

Specifications
▷ Type: Hall effect sensor
Operation condition [°C(°F)]
((-)40~150)) -40~302
Air gap(mm)in.
(0.95~1.65)0.037~0.065
Output voltage(V)
High
1.18~1.68
Low
0.59~0.84

    Description Input speed sensor is a vital unit that measures the rate of rotation of the input shaft inside the transaxle and delivers the readings to the Transaxle Control Module(TCM).

    Circuit Diagram

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Repair procedures

    Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. The procedure starts with an PCM(ECM) request for vehicle specific data (PIN code: 6digits) from the tester.

    Kia Cadenza YG 2016-2021 Service Manual: Cluster ionizer Repair procedures

    Inspection 1. Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch. DisplayFail description00Normal50Cluster ionizer fault * Diagnostic procedure refer to DTC code. Replacement 1. Disconnect the negative (-) battery terminal.

    Categories

     
    Copyright © 2025 www.kcadenzavg.com - 0.0235