Kia Cadenza YG: Automatic Transaxle Control System / Line Pressure Control Solenoid Vale Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Line Pressure Control Solenoid Vale Repair procedures

Inspection
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the solenoid valve connector (A).

4.
Measure the resistance between power terminal (5) and signal terminal (17).
Specification : 5.1 ± 0.3 Ω

Replacement
   
If a solenoid valve of VFS type needs to be replaced, the valve body assembly should be replaced and the oil pressure should be adjusted. If the solenoid valve is replaced individually, it is not possible to adjust the oil pressure without additional equipment, and if the oil pressure adjustment procedure is not performed, a shift shock or delay may occur.
1.
Replace the valve body assembly.
(Refer to Hydraulic System - "Valve Body")

    Circuit Diagram

    Specification ItemSpecificationControl type ON/OFFCurrent value (mA)5.0 Coil resistance(Ω)10 ~ 11 

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Auto Head lamp leveling Unit Repair procedures

    Removal Height Sensor 1. Remove the height sensor connector (A). 2. Loosen the mounting bolts(Body: 2EA, chassis: 1EA) from height sensor bracket. Tightening torque : 3 ~ 5N.m (30 ~ 50kgf.m, 2.21 ~ 3.68lb-ft) 3. Remove the height sensor.

    Kia Cadenza YG 2016-2021 Service Manual: Troubleshooting

    Troubleshooting Problem Symptoms Table Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor. Use the table below to help you find the cause of the problem.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0285