Kia Cadenza YG: Hydraulic System / Oil Pump Components and Components Location
| Components |
| 1. Reaction shaft support assembly 2. Oil pump housing 3. Driven gear 4. Drive gear 5. Oil seal | 6. Bush-Housing 7. Reaction shaft 8. Bush- Reaction shaft 9. Sleeve 10. Bolt |
| 1. Inhale(Oil filter) 2. Inhale(Valve body) 3. Outlet 4. 26/B operation pressure | 5. 35R/C operation pressure 6. Lubrication 7. Line up clutch operation pressure 8. Line up clutch cancellation |
Description The oil pump is built-in as a single unit with the 26 Brake chamber. Rotation of the pump builds the hydraulic pressure needed for the lubrication of the various parts of the transaxle and operation of the clutch and brakes.
Components Location 1. Injection hole(eyebolt)2. Oil level plug3. Oil drain plug
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Immobilizer Control Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening the bolt. Installation 1.
Kia Cadenza YG 2016-2021 Service Manual: Parking Assist Sensor Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper cover. (Refer to Body - "Rear Bumper Cover") 3. Disconnect the connector (A) from the parking assist sensor. 4. Pull out the sensor (A) by opening the sensor holder (B) out.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Engine Control / Fuel System
- Emission Control System
- Steering System
- New on site
- Most important about car
