Kia Cadenza YG: Engine Control System / Rail Pressure Sensor (RPS) Specifications
| Specification |
| Pressure [MPa (kgf/cm², psi)] | Output Voltage (V) |
| 0 (0, 0) | 0.5 |
| 10 (102, 1450) | 2.5 |
| 20 (204, 2900) | 4.5 |
Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal.
Signal Waveform
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Auto Head lamp leveling Unit Repair procedures
Removal Height Sensor 1. Remove the height sensor connector (A). 2. Loosen the mounting bolts(Body: 2EA, chassis: 1EA) from height sensor bracket. Tightening torque : 3 ~ 5N.m (30 ~ 50kgf.m, 2.21 ~ 3.68lb-ft) 3. Remove the height sensor.
Kia Cadenza YG 2016-2021 Service Manual: Surround View Monitoring Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the floor console upper cover. (Refer to Body - "Floor Console Assembly") 3. Disconnect the console upper cover connector (A). 4. Remove the cup holder assembly (A) after loosening the mounting screws.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Crankshaft Damper Pulley Components and Components Location
- Body Control Module (BCM) Description and Operation
- Battery Troubleshooting
- New on site
- Most important about car
