| Inspection |

| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the rear package tray (A) after removing the rear seat. (Refer to the Body group- interior trim)
|
| 3. |
Remove the rear curtain (A) after removing the connector and bolts (8EA).
|
| 4. |
If necessary of removing the rear curtain motor (A), remove the screws (3EA).
|
| Installation |
| 1. |
Install the rear curtain and connector. |
| 2. |
Install the rear package tray and rear seat. |
| 3. |
Connect the negative (-) battery terminal. |
Circuit Diagram Rear Curtain Unit Connector PIN NO.ConnectorPIN NO.Connector1B+8IG22-9Inhibitor “R” switch3Power GND10Rear curtain switch4Power B+11Vehicle speed sensor5-12Inhibitor “P” switch6Motor UP13-7Signal GND14Motor DOWN
Inspection 1. AUTO UP/AUTO DOWN function (1) IGN ON, if you press the rear curtain switch, rear curtain motor operates the reverse direction of the before direction.
Description Surround View Monitoring System (SVM) is the system that allows video monitoring of 360 degrees around the vehicle. The system includes 4 ultra optical camera mounted around the vehicle (front, both sides, rear). The video from these cameras are applied with distortion compensation, time point conversion, and video merging
Inspection 1. Measure terminal - to - terminal resistance of blower resistor. 2. If measure resistance isnot within specification, the blower resistor must be replaced. Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower cover (A) and then disconnect the connector (B).