Kia Cadenza YG: Rear Curtain System / Schematic Diagrams
| Circuit Diagram |
| Rear Curtain Unit Connector |
| PIN NO. | Connector | PIN NO. | Connector |
| 1 | B+ | 8 | IG2 |
| 2 | - | 9 | Inhibitor “R” switch |
| 3 | Power GND | 10 | Rear curtain switch |
| 4 | Power B+ | 11 | Vehicle speed sensor |
| 5 | - | 12 | Inhibitor “P” switch |
| 6 | Motor UP | 13 | - |
| 7 | Signal GND | 14 | Motor DOWN |
Description You can up & down rear curtain automatically by pressing the rear curtain switch. Rear curtain protect passenger from a direct ray of light by covering rear glass.
Inspection Connect the battery voltage and check the rear curtain motor rotation. If the motor does not operate properly, substitute with a known-good rear curtain motor and check for proper operation.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting screws. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Kia Cadenza YG 2016-2021 Service Manual: Temperature Control Actuator Repair procedures
Inspection 1. Ignition "OFF" 2. Disconnect the connector of temperature control actuator. 3. Verify that the temperature control actuator operates to the hot position when connecting 12V to the terminal 3 and grounding terminal 7. Verify that the temperature control actuator operates to the cool position when connecting in the rev
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Engine Control / Fuel System
- Transaxle Control Module (TCM) Repair procedures
- Body Electrical System
- New on site
- Most important about car
