Kia Cadenza YG: Rear Curtain System / Description and Operation
| Description |
The rear curtain provides shade for the rear seat passengers and can be raised or lowered by using the rear curtain switch. |
Component Location 1. Rear curtain2. Rear curtain switch 3. Rear curtain unit
Circuit Diagram Rear Curtain Unit Connector PIN NO.ConnectorPIN NO.Connector1B+8IG22-9Inhibitor “R” switch3Power GND10Rear curtain switch4Power B+11Vehicle speed sensor5-12Inhibitor “P” switch6Motor UP13-7Signal GND14Motor DOWN
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Mode Control Actuator Repair procedures
Inspection 1. Ignition "OFF” 2. Disconnect the connector of mode control actuator. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the terminal 3and grounding terminal 7. 4. Verify that the mode control actuator operates to the vent mode when connecting in the reverse.
Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower unit.(Refer to HA group – heater unit). 3. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws. Make sure that there is no air leaking out of the blower and duct joints.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- General Information
- Engine Electrical System
- Driveshaft and axle
- New on site
- Most important about car
