Kia Cadenza YG: Heater / Temperature Control Actuator Description and Operation
| Description |
| 1. |
Heater unit includes mode control actuator and temperature control actuator. |
| 2. |
Temperature control actuator is located at the heater unit.
It regulates the temperature by the procedure as follows. Signal from
control unit adjusts position of temperature door by operating
temperature switch and then temperature will be regulated by the
hot/cold air ratio decided by position of temperature door |
Component Location
Inspection 1. Ignition "OFF" 2. Disconnect the connector of temperature control actuator. 3. Verify that the temperature control actuator operates to the hot position when connecting 12V to the terminal 3 and grounding terminal 7.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Surround View Monitoring Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing. (Refer to Body - "Glove Box Housing") 3. Remove the SVM unit (B) after disconnecting the connectors (A) and mounting bolts. Installation 1. Install the SVM unit.
Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the passenger compartment junction box cover. 3. Remove the driver side cover (A). 4. Remove the crash pad side switch assembly (A) by pushing it through side cover hole.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Restraint
- Body Control Module (BCM) Description and Operation
- General Information
- New on site
- Most important about car
