Kia Cadenza YG: Heating,Ventilation, Air Conditioning / Heater
- Heater Unit Components and Components Location
- Heater Unit Repair procedures
- Temperature Control Actuator Components and Components Location
- Temperature Control Actuator Description and Operation
- Temperature Control Actuator Repair procedures
- Mode Control Actuator Components and Components Location
- Mode Control Actuator Description and Operation
- Mode Control Actuator Repair procedures
- Auto defoging actuator Components and Components Location
- Auto defoging actuator Repair procedures
Inspection 1. Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch. DisplayFail description00Normal50Cluster ionizer fault * Diagnostic procedure refer to DTC code.
Component Location Components 1. Heater Case (LH)2. Separator3. Evaporator Core4. Shower Duct (LH)5. Heater Core Cover6. Heater Core7. Mode Actuator8.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Repair procedures
Inspection Tolerance Calibration Tolerance calibration compensates for the error margins of surround view video that occur due to the installation tolerance when the four cameras that comprise the SVM system are installed. You must carry out tolerance calibration if you do any of the following.
Kia Cadenza YG 2016-2021 Service Manual: Evaporator unit Repair procedures
Inspection 1. Ignition "OFF". 2. Disconnect evaporator temperature sensor. 3. Using the multi-tester, Measure resistance between terminal "1" and "2" of evaporator temperature sensor. Specification Evaporator coretemperature [°C(°F)]Resistance[KΩ]Voltage[V]-20(-4)70.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Timing Chain Repair procedures
- Body Electrical System
- General Information
- New on site
- Most important about car
