Kia Cadenza YG: Heater / Mode Control Actuator Description and Operation

Kia Cadenza YG 2016-2021 Service Manual / Heating,Ventilation, Air Conditioning / Heater / Mode Control Actuator Description and Operation

Description
The mode control actuator is located at the heater unit.
It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch makes the mode control actuator shift in order of vent→ B/L → floor → mix.

    Component Location

    Inspection 1. Ignition "OFF” 2. Disconnect the connector of mode control actuator. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the terminal 3and grounding terminal 7.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Start/Stop Button Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screw driver or remover, remove the center fascia lower panel (A). 3. Remove the in-car hose (A) and disconnect the connectors (B) from the heater & A/C control unit. 4.

    Kia Cadenza YG 2016-2021 Service Manual: Repair procedures

    Removal 1. Remove the trunk trim in the trunk after removing the screws and clips. (Refer to Body - "Trunk") 2. Remove the camera holder (A) as shown arrow direction, and then remove the back view camera (B). Installation 1. Install the back view camera and camera holder.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0207