| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the passenger compartment juction box cover. |
| 3. |
Remove the crash pad side switch assembly (A) by pushing it through juction box cover hole.
|
| 4. |
Remove the rear curtain switch (A) after disconnecting the connectors.
|
| Installation |
| 1. |
Install the rear curtain switch and connector to the crash pad. |
| 2. |
Install the passenger compartment juction box cover. |
| Inspection |
| 1. |
Operate the switch and check for continuity between terminals with an ohmmeter.
|
Inspection 1. AUTO UP/AUTO DOWN function (1) IGN ON, if you press the rear curtain switch, rear curtain motor operates the reverse direction of the before direction.
Inspection 1. Ignition "ON" 2. Using the scan tool. 3. Emit intensive light toward photo sensor using a lamp, and check the output voltage change. 4. The voltage will rise with higher intensive light and reduce with lower intensive light.
Component Location Components 1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Blower Upper Case10. Blower Lower Case11. FET12. Resistor13.