Kia Cadenza YG: SRSCM / Seat Belt Buckle Switch (BS) Description and Operation
Kia Cadenza YG 2016-2021 Service Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS) Description and Operation
| Description |
The SRSCM shall monitor the status of the driver and front
passenger seat belt buckle. The SRSCM provides one pin each for the
driver and front passenger seat belt buckle status input. The seat belt
buckle circuit operates from internal boost voltage supplied by the
SRSCM, and uses chassis ground for the signal return. The buckle status
shall modify the SRSCM deployment. If the buckle status is unbuckled,
the corresponding pretensioner will not be deactivated.
Removal Pressure Side Impact Sensor • Removal of the airbag must be performed according to the precautions/procedures described previously.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Height Sensor Repair procedures
Removal Height Sensor 1. Disconnect the negative (-) battery terminal. 2. Remove the height sensor linkage (A) installed on the front axle and rear axle. [Front] [Rear] Installation Height Sensor 1. Install the height sensor assembly after connecting the connector.
Kia Cadenza YG 2016-2021 Service Manual: Schematic Diagrams
C
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Automatic Transaxle System
- Engine Mechanical System
- Alternator Schematic Diagrams
- New on site
- Most important about car
Copyright © 2026 www.kcadenzavg.com - 0.0321