Inspect the sound from speaker after verifying that the
speaker mounting screws are removed and the wiring connector is
connected to remove any possible vibration transmitted from body trims
and surrounding parts.
(2)
Case Troubleshooting
No.
Case
Inspection/Remedy
1
Trembling sound
1)
Before replacing the speaker, inspect that the mounting screw is installed normally.
2)
After re-installing the speaker, verify that no trembling sound is heard.
3)
When hearing a trembling sound again, replace the speaker with new one.
2
Noise
1)
Check if the wiring connector is connected normally. If not, reconnect the wiring connector.
2)
In case of radio static, check if there is a noise from CD.
3)
When a noise is heard on turning radio and CD on, replace the speaker with new one.
In case there is only radio static, this causes from poor radio reception. Thus the speaker needs no repair and replacement.
3
Poor working
Inspection of the wiring connection between the battery and the speaker
1)
Before replacing the speaker, inspect the wiring connection between the battery and the speaker is normal.
2)
Check the supply power to the speaker and the resistance, then inspect the sound quality.
Removal
Audio Head Unit
•
Take care not to scratch the center fascia panel and related parts.
•
Eject all the disc before removing the audio unit to prevent damaging the CD player''s load mechanism.
Inspection
Glass Antenna Test
1.
Wrap aluminum foil (A) around the tip of the tester probe (B) as shown.
2.
Touch one tester probe to the glass antenna terminal (A) and
move the other tester probe along the antenna wires to check that
continuity exists.
Description
The used radar frequency of BSD is two, "North America region" and "Except North America region".
If it replaces BSD unit, BSD unit has to perform the procedure of variant coding.
BSD Variant Coding
1.
Select the "BSD Variant Coding" procedure in BSD system.
Troubleshooting
Problem Symptoms Table
Before replacing or repairing air conditioning components,
first determine if the malfunction is due to the refrigerant charge, air
flow or compressor.
Use the table below to help you find the cause of the
problem.
