| Specification |
| Item | Specification | |
| Model | RADIO/CD/MP3 (PA30B) | |
| Power supply | DC 14.4V | |
| Rated output | Max 43W x 4 | |
| Impedanec (Ω) | 4 ohm x 4 | |
| Antenna | 80PF 75Ω | |
| Tuning type | PLL synthesized type | |
| Other | Internal amplifier | |
| Frequency range / Channel space | FM | 87.5 ~ 107.9 MHz/200 KHz |
| AM | 530 ~ 1710 KHz/10 KHz | |
| Item | PA30B | ||
| Input power (W or V) | Front | MAX 50W | |
| Rear | MAX 50W | ||
| Front tweeter | MAX 40W | ||
| Impedance (Ω) | Front | 4 ± 0.6 | |
| Rear | 2.0 ± 0.3 | ||
| Front tweeter | 3.4 ± 0.5 | ||
| Number of speaker | 6 | ||
Component Location 1. Audio unit2. Front tweeter speaker3. Glass antenna amplifier (Diversity type)4. Front door speaker5. Rear speaker6. Antenna feeder cable7.
Inspection 1. Ignition "ON" 2. Using the scan tool. 3. Emit intensive light toward photo sensor using a lamp, and check the output voltage change. 4. The voltage will rise with higher intensive light and reduce with lower intensive light.
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower unit.(Refer to HA group – heater unit). 3. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws. Make sure that there is no air leaking out of the blower and duct joints.