| Specification |
| Items | Specification |
| Rated voltage | DC 12V |
| Operating voltage | DC 9 ~ 16V |
| Operating temperature | -30°C ~ 75°C (-22°F ~ 167°F) |
| Dark current | Max 2.9mA (When welcome light function on : Max 4.9 mA) |
| Items | Specification |
| Frequency | 315 MHz |
| Antenna type | FSK (Frequency Shift Keying) |
| Items | Specification | ||||
| Battery | Lithium battery 3V 1EA (CR2032) | ||||
| Distance | 30m from vehicle, RF : 30m, Passive(LF) : 0.7m | ||||
| Battery life | More than 2years (10 times / a day)
| ||||
| Push buttons | 4 (Door lock / unlock, Trunk lid open, Panic) | ||||
| Frequency(Rx) | 125 kHz | ||||
| Frequency(Tx) | 315 MHz | ||||
| Numbers | 2EA |
| Items | Specification |
| Rated voltage | DC 12V |
| Operating voltage | DC 9 ~ 16V |
| Operating temperature | -30°C ~ 75°C (-22°F ~ 167°F) |
| Frequency | 125kHz |
| Numbers | Interior(3EA), Door(2EA), Bumper(1EA) |
Component Location (1) 1. Buzzer2. Smart key unit3. RF receiver4. Interior antenna 15. Interior antenna 26. Trunk antenna7. Bumper antenna Component Location (2) 1.
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting screws. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the passenger compartment junction box cover. 3. Remove the driver side cover (A). 4. Remove the crash pad side switch assembly (A) by pushing it through side cover hole.