Kia Cadenza YG: Button Engine Start System / Start/Stop Button Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Body Electrical System / Button Engine Start System / Start/Stop Button Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Using a screw driver or remover, remove the center fascia lower panel (A).

3.
Remove the in-car hose (A) and disconnect the connectors (B) from the heater & A/C control unit.

4.
Using a screw driver or remover, remove the crash pad garnish [RH] (A).

5.
Remove th AVN head unit (A) after loosening the mounting screws.

6.
Disconnect the connectors (A) from the AVN head unit.

7.
Using a screw driver or remover, remove the crash pad side cover (A).

8.
Remove the crash pad lower panel (A) after loosening the mounting screws.

9.
Disconnect the connectors (A).

10.
Remove the crash pad center panel (A) after loosening the mounting screws.

11.
Remove the ignition key grommet (A) after loosening the mounting screws.

12.
Disconnect the start/stop button connector (A).

13.
Remove the start/stop button (A) by pushing the both sides of the hooks.

Installation
1.
Install the start/stop button.
2.
Install the crash pad center panel, crash pad lower panel, AVN head unit, heater & A/C control unit and center fascia lower panel.

    Component

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Auto defoging sensor Repair procedures

    Inspection 1. Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch. DisplayFail description00Normal23Auto defog sensor OPEN24Auto defog sensor SHORT43Defog door potentiometer OPEN/SHORT44Defog door potentiometer * Diagnostic procedure refer to DTC code.

    Kia Cadenza YG 2016-2021 Service Manual: Temperature Control Actuator Repair procedures

    Inspection 1. Ignition "OFF" 2. Disconnect the connector of temperature control actuator. 3. Verify that the temperature control actuator operates to the hot position when connecting 12V to the terminal 3 and grounding terminal 7. Verify that the temperature control actuator operates to the cool position when connecting in the rev

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0302