Kia Cadenza YG: Automatic Transaxle Control System / Transaxle Oil Temperature Sensor Description and Operation
Kia Cadenza YG 2016-2021 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Transaxle Oil Temperature Sensor Description and Operation
| Description |
Transaxle oil temperature sensor monitors the automatic
transaxle fluid''s temperature and conveys the readings to TCM. It is an
Negative Thermal Coefficient(NTC) sensor whose resistance has an
inversely proportional relationship with the temperature level. Data
produced by this sensor is used to identify damper clutch activation and
deactivation zones within the low temperature and high temperature
range and to compensate hydraulic pressure levels during gear changes.
Removal When replacing the TCM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the case of installing used TCM] 1) Perform "TCM Neutral mode" procedure with GDS.
Specifications ▷ Type: Negative Thermal Coefficient(NTC) Type Temp.[(°C)°F]Resistance (kΩ)(-40)-4048.1(-20)-4.015.6(0)32.05.88(20)68.02.51(40)104.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Cluster ionizer Repair procedures
Inspection 1. Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch. DisplayFail description00Normal50Cluster ionizer fault * Diagnostic procedure refer to DTC code. Replacement 1. Disconnect the negative (-) battery terminal.
Kia Cadenza YG 2016-2021 Service Manual: Heater & A/C Control Unit (DATC) Components and Components Location
C
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Rail Pressure Sensor (RPS) Schematic Diagrams
- Steering System
- Components and Components Location
- New on site
- Most important about car
Copyright © 2026 www.kcadenzavg.com - 0.0286