Kia Cadenza YG: Air Conditioning System / Photo Sensor Description and Operation
| Description |
| 1. |
The photo sensor is located at the center of defrost nozzle. |
| 2. |
The photo sensor contains a photovoltaic (sensitive to
sunlight) diode. The solar radiation received by its light receiving
portion, generates an electromotive force in proportion to the amount of
radiation received which is transferred to the automatic temperature
control module so that the solar radiation compensation will be
performed. |
Inspection 1. Ignition "OFF". 2. Disconnect evaporator temperature sensor. 3. Using the multi-tester, Measure resistance between terminal "1" and "2" of evaporator temperature sensor.
Inspection 1. Ignition "ON" 2. Using the scan tool. 3. Emit intensive light toward photo sensor using a lamp, and check the output voltage change.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Cluster ionizer Repair procedures
Inspection 1. Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch. DisplayFail description00Normal50Cluster ionizer fault * Diagnostic procedure refer to DTC code. Replacement 1. Disconnect the negative (-) battery terminal.
Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Components and Components Location
Component Location Components 1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Blower Upper Case10. Blower Lower Case11. FET12. Resistor13.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Driveshaft and axle
- Engine Electrical System
- Battery Troubleshooting
- New on site
- Most important about car
