Kia Cadenza: Rear Suspension System / Rear Cross Member Repair procedures

Kia Cadenza YG 2016-2025 Service Manual / Suspension System / Rear Suspension System / Rear Cross Member Repair procedures

Replacement
1.
Remove the rear wheel & tire.

Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

   
Be careful not to damage to the hub bolts when removing the rear wheel & tire.
2.
Remove the rear lower arm.
(Refer to Rear Suspension System - "Rear Lower Arm")
3.
Remove the rear shock absorber.
(Refer to Rear Suspension System - "Rear Shock Absorber")
4.
Remove the rear upper arm.
(Refer to Rear Suspension System - "Rear Upper Arm")
5.
Remove the trailing arm.
(Refer to Rear Suspension System - "Trailing Arm")
6.
Remove the rear assist arm.
(Refer to Rear Suspension System - "Rear Assist Arm")
7.
Remove the rear muffler.

8.
Loosen the mounting bolts and then remove the rear cross member with the frame.

Tightening torque:
156.9 ~ 176.5N.m (16.0 ~ 18.0kgf.m, 115.7~130.2lb-ft)

9.
Installation is the reverse of removal.
Trailing Arm Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage to the hub bolt ...

Tires/Wheels
...

Other information:

Kia Cadenza YG 2016-2025 Service Manual: Front Driveshaft Repair procedures


Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub. Tightening torque: 88.2 ~ 107.8N.m (9.0 ~ 11.0kgf.m, 65.0 ~ 79.5lb-ft)     Be careful not to damag ...

Kia Cadenza YG 2016-2025 Service Manual: Fuel Pressure Control Valve (FPCV) Description and Operation


Description Fuel Pressure Control Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on various engine condition. ...

Copyright © www.kcadenzavg.com 2017-2025