Kia Cadenza YG: Rear Suspension System / Trailing Arm Repair procedures
| Replacement |
| 1. |
Remove the rear wheel & tire.
|
| 2. |
Disconnect the parking brake cable (A) with the rear brake assembly.
|
| 3. |
Loosen the parking brake cable bracket nuts (A) &
trailing arm mounting bolts (B) and then remove the trailing arm with
the rear axle.
|
| 4. |
Loosen the parking brake cable bracket bolt (A) & height sensor bracket bolt (B). |
| 5. |
Loosen the mounting bolt and then remove the trailing arm (C) from the body.
|
| 6. |
Installation is the reverse of removal. |
Replacement 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) Be careful not to damage to the hub bolts when removing the rear wheel & tire.
Replacement 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) Be careful not to damage to the hub bolts when removing the rear wheel & tire.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Repair procedures
Removal 1. Remove the trunk trim in the trunk after removing the screws and clips. (Refer to Body - "Trunk") 2. Remove the camera holder (A) as shown arrow direction, and then remove the back view camera (B). Installation 1. Install the back view camera and camera holder.
Kia Cadenza YG 2016-2021 Service Manual: Ambient Sensor Repair procedures
Inspection 1. Ignition "OFF" 2. Disconnect ambient temperature sensor. 3. Check the resistance of ambient temperature sensor between terminals 1 and 2 whether it is changed by changing of the ambient temperature. 1. Sensor Ground2.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Restraint
- Engine Electrical System
- Components and Components Location
- New on site
- Most important about car
