Inspect the sound from speaker after verifying that the
speaker mounting screws are removed and the wiring connector is
connected to remove any possible vibration transmitted from body trims
and surrounding parts.
(2)
Case Troubleshooting
No.
Case
Inspection/Remedy
1
Trembling sound
1)
Before replacing the speaker, inspect that the mounting screw is installed normally.
2)
After re-installing the speaker, verify that no trembling sound is heard.
3)
When hearing a trembling sound again, replace the speaker with new one.
2
Noise
1)
Check if the wiring connector is connected normally. If not, reconnect the wiring connector.
2)
In case of radio static, check if there is a noise from CD.
3)
When a noise is heard on turning radio and CD on, replace the speaker with new one.
In case there is only radio static, this causes from poor radio reception. Thus the speaker needs no repair and replacement.
3
Poor working
Inspection of the wiring connection between the battery and the speaker
1)
Before replacing the speaker, inspect the wiring connection between the battery and the speaker is normal.
2)
Check the supply power to the speaker and the resistance, then inspect the sound quality.
Removal
AVN Head Unit
•
Take care not to scratch the center fascia panel and related parts.
•
Ejact all the disc before removing the AVN head unit to prevent damaging the CD player''s load mechanism.
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
3.
Disconnect the connector (A) from the parking assist sensor.
4.
Pull out the sensor (A) by opening the sensor holder (B) out.
Inspection
1.
Connect the battery voltage and check the blower motor rotation.
2.
If the blower motor voltage is not operated well, substitute with a known-good blower motor and check for proper operation.
3.
If the problem is corrected, replace the blower motor.
