Kia Cadenza YG: Body Electrical System / AVN System
- Specifications
- Components and Components Location
- Schematic Diagrams
- Description and Operation
- AVN Head Unit Components and Components Location
- AVN Head Unit Repair procedures
- Speaker Repair procedures
- Roof Antenna Repair procedures
- Steering Wheel Remote Controller (SWRC) Components and Components Location
- Steering Wheel Remote Controller (SWRC) Schematic Diagrams
- Steering Wheel Remote Controller (SWRC) Repair procedures
- Multimedia Jack Schematic Diagrams
- Multimedia Jack Description and Operation
- Multimedia Jack Repair procedures
Inspection Test the horn by connecting battery voltage to the 1 terminal and ground the 2 terminal. The horn should make a sound. If the horn fails to make a sound, replace it.
Specifications AVN Head Unit ItemSpecificationPower sourceDC 14.4V (-) groundFrequency range / Channel spaceFM : 87.5 ~ 107.9 MHz / 200 KHzAM : 530 ~ 1710 KHz / 10 KHzTuning typePLL SYNTHESIZED TUNINGImpedance2 ohm x 4Antenna80 pF 75 OhmDark currentMax.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Components and Components Location
Component Location Components 1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Blower Upper Case10. Blower Lower Case11. FET12. Resistor13.
Kia Cadenza YG 2016-2021 Service Manual: Blower Motor Repair procedures
Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor voltage is not operated well, substitute with a known-good blower motor and check for proper operation. 3. If the problem is corrected, replace the blower motor.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Body Electrical System
- Engine Control / Fuel System
- Restraint
- New on site
- Most important about car
