Kia Cadenza YG: Rear Parking Assist System / Specifications

Kia Cadenza YG 2016-2021 Service Manual / Body Electrical System / Rear Parking Assist System / Specifications

Specification
Item
Specification
Ultrasonic sensor
Voltage rating
DC 12 V
Detecting range
30 cm ~ 120 cm
Operation voltage
DC 9 ~ 16 V
Operation current
MAX 300 mA
Operation temperature
-30°C ~ +80°C (-22°C ~ +176°C)
Operation frequency
48 ± 5 KHz
Effective operating velocity
10 KPH (6.2 MPH)
Number of sensors
4 (Left side, Left center, Right center, Right side)

※ Rear parking assist control unit function is built in IPM (Intelligent integrated Platform Module).

    Component Location 1. BCM (Body Control Module)2. Ultrasonic sensor ※ Rear parking assist control unit function is built in IPM (Intelligent integrated Platform Module).

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Antenna Coil Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening the screw.

    Kia Cadenza YG 2016-2021 Service Manual: Description and Operation

    Description BSD is a system that uses two magnetic wave radar sensors attached on the rear bumper to measure the distance from the following vehicles and provides the sensing and (visual and auditory) alarm of any vehicle coming into the blind spot.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0353